How to Put On and Take Off a One-Piece Race Suit (Without the Struggle)

The first time most riders try to get into a new set of one-piece leathers, it turns into a hopping, sweating fight in the corner of the garage. That’s normal. A race suit is cut to fit you in a riding crouch, not standing up straight, and new leather hasn’t softened yet. With the right order of steps, getting in and out takes a couple of minutes and puts far less strain on the zips and seams.

Before you start

  • Wear a base layer. Bare skin grips leather and makes everything harder. A thin, close-fitting technical layer lets the suit slide on. We cover the options in what to wear under race leathers.
  • Undo every zip fully. Main zip right down to the bottom, plus any sleeve, calf or ankle zips your suit has. A half-open zip is the most common reason riders get stuck.
  • Take your boots off. Boots go on after the suit, never before.
  • Find somewhere to sit. A chair, a bench or the tailgate of a van makes the legs much easier.

How to put on a one-piece race suit, step by step

  1. Legs first, sitting down. Open the suit and sit with it in front of you. Point your toes and slide one leg in, then the other, working each leg down until your foot comes out of the bottom. If your foot catches, a thin sock over the base layer helps.
  2. Stand up and pull the suit to your waist. Grip the leather at the hips, not the zip, and ease it up. Check the knee armour is sitting over your kneecaps before you go further. If it’s low now, it will stay low.
  3. Bend forward slightly. Leaning into a gentle crouch gives you the slack you need in the back. This is the trick most people miss: the suit is shaped for that position, so stop fighting it standing upright.
  4. Your stronger arm goes in first. Reach into the sleeve and push your hand through, keeping your elbow bent. Then shrug that shoulder into place.
  5. Second arm. Reach behind you, find the other sleeve and slide in. It feels awkward the first few times. Some riders find it easier to hold the second shoulder of the suit with the first hand and guide it over.
  6. Settle the armour. Roll your shoulders and bend your elbows a few times so the shoulder and elbow protectors drop onto the joints. The back protector should run straight down your spine.
  7. Close the main zip slowly, in a crouch. Hold the bottom of the zip with one hand and pull the slider with the other. If it binds, don’t force it: lean further forward, breathe out and try again.
  8. Close the collar, then the cuffs and calves. Then put your boots on and close any calf zips over or under them, depending on how your boots and suit are designed to work together.

How to take off a one-piece race suit

  1. Boots and gloves off first.
  2. Open the collar, then pull the main zip all the way down while leaning slightly forward.
  3. Open sleeve and calf zips if your suit has them.
  4. Slip one shoulder back and pull that arm out, holding the cuff with the other hand so the sleeve doesn’t turn inside out. Repeat on the other side.
  5. Push the suit down to your hips, sit down and pull the legs off one at a time by the ankle.

On a hot track day the leather will stick to you. A friend pulling the sleeves while you keep your arms straight is the fastest fix, and it’s very common in the paddock.

Protect the suit while you’re doing it

  • Never pull on the zip to drag the suit up. Pull on the leather. Zips carry a lot of load when you’re tucked on the bike, so treat them gently off it.
  • Keep the zip clean. Grit from the paddock makes the slider stiff. Brush it out after the day, and see our leather suit care guide for cleaning.
  • Hang it open. Store the suit on a wide hanger with the zip undone so the leather and armour keep their shape. Taking it off the bike for winter? Read how to store a leather race suit over winter.

Is it hard because the suit doesn’t fit?

A new suit is always firm, and it gets easier as the leather softens over the first few rides (our break-in guide explains how to speed that up). But some signs point to a fit problem, not a break-in problem:

  • You can’t close the main zip even in a full crouch.
  • Your knee or elbow armour sits well away from the joint once the suit is zipped.
  • The suit pulls hard across your shoulders when you reach forward to the bars.
  • You lose feeling in your hands or legs after a short session.

If that sounds familiar, the answer is usually a suit cut to your own measurements rather than a bigger off-the-rack size. Bigger sizes move the armour off your joints. Our guide on choosing the right race suit size walks through the key measurements.

Made to your measurements

Every Racers Arena suit is made to order. Browse our motorcycle leather race suits, or design your own colours and graphics in the custom leather race suit collection. Suits have Kevlar panels and CE certified armour, with standard CE Level 1 protectors and a CE Level 2 upgrade available. Standard suits take 12–16 business days to make plus 6–8 days for delivery, and fully custom designs take about 4 weeks.

Finishing the kit? Pair the suit with leather racing gloves and motorcycle racing boots so the cuffs and ankles overlap properly.

Quick answers

Should I put my boots on before my race suit? No. Suit first, then boots, then close the calf area according to how your boots and suit fit together.

Why won’t my race suit zip up? Usually because you’re standing straight. Lean into a riding crouch and breathe out. If it still won’t close, the suit may be too small through the torso.

Does a one-piece suit get easier to put on? Yes. The leather softens over the first few rides, and after a handful of track days most riders are in and out in a couple of minutes.

Leave a Comment